Technical ArticlesNo Comments

default thumbnail

Sometimes Windchill installers fails while doing base data load operation.

Here is the alternate manual method to do same thing.

1. Open a Windchill Shell and execute below command.

                windchill wt.load.WindchillLoader -info

This command will give list of installed  Windchill modules. now use below command to load base data.

Here are the options :
a. Load base data for all installed application.

windchill wt.load.WindchillLoader -All -unattended

b. Load base data along with demo data

windchill wt.load.WindchillLoader -All -IncludeDemo -unattended

c. Load only Demo Data

         windchill wt.load.WindchillLoader -All -LoadOnlyDemo -unattended

d. Load base data along with Test Data

windchill wt.load.WindchillLoader -All -LoadOnlyTest -unattended

e. Load base data for particular application like MPMLink.

windchill wt.load.WindchillLoader -Application=Windchill.MPMLink -unattended

f. for Help, use below command

windchill wt.load.WindchillLoader -help

Be the first to post a comment.

Add a comment